<4>Loading R[23]00 MMU routines.
<4>CPU revision is: 00000220
<4>Instruction cache 64kb
<4>Data cache 64kb
<4>Linux version 2.2.1 (airlied@intel11.ece.ul.ie) (gcc version egcs-2.90.27 980315 (egcs-1.0.2 release)) #166 Tue May 18 17:04:10 IST 1999
<4>Calibrating delay loop... 24.84 BogoMIPS
<4>Memory: 14652k/16380k available (1068k kernel code, 400k data)
<4>Checking for 'wait' instruction...  unavailable.
<4>POSIX conformance testing by UNIFIX
<4>TURBOchannel rev. 1 at 25.0 MHz (no parity)
<4>    slot 5: DEC      PMAZ-AA  V5.3b   
<4>    slot 6: DEC      PMAD-AA  V5.3a   
<6>Linux NET4.0 for Linux 2.2
<6>Based upon Swansea University Computer Society NET3.039
<6>NET4: Unix domain sockets 1.0 for Linux NET4.0.
<6>NET4: Linux TCP/IP 1.0 for NET4.0
<6>IP Protocols: ICMP, UDP, TCP
<4>Starting kswapd v 1.5 
<4>DECstation DZ serial driver version 1.02
<4>ttyS00 at 0xbfe00000 (irq = 4)
<4>ttyS01 at 0xbfe00000 (irq = 4)
<4>ttyS02 at 0xbfe00000 (irq = 4)
<4>ttyS03 at 0xbfe00000 (irq = 4)
<4>pty: 256 Unix98 ptys configured
<4>RAM disk driver initialized:  16 RAM disks of 4096K size
<4>SCSI ID 7  Clock 25 MHz CCF=5 Time-Out 167 NCR53C9x(esp236) detected
<4>ESP: Total of 1 ESP hosts found, 1 actually in use.
<4>scsi0 : ESP236
<4>scsi : 1 host.
<4>  Vendor: MICROP    Model: 1528-15MD1066702  Rev: DD24
<4>  Type:   Direct-Access                      ANSI SCSI revision: 01 CCS
<4>Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
<4>  Vendor: DEC       Model: RZ55     (C) DEC  Rev: 0900
<4>  Type:   Direct-Access                      ANSI SCSI revision: 01 CCS
<4>Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
<4>scsi : detected 2 SCSI disks total.
<6>esp0: Disabling DISCONNECT for target 0 lun 0
<6>esp0: target 0 [period 200ns offset 15 5.00MHz synchronous SCSI]
<4>SCSI device sda: hdwr sector= 512 bytes. Sectors= 2621688 [1280 MB] [1.3 GB]
<4>SCSI device sdb: hdwr sector= 512 bytes. Sectors= 649040 [316 MB] [0.3 GB]
<4>declance.c: v0.008 by Linux Mips DECstation task force
<4>eth0: PMAD-AA, addr = 08:00:2b:1c:50:52, irq = 3
<5>Sending BOOTP requests.... OK
<4>IP-Config: Got BOOTP answer from 136.201.105.129, my address is 136.201.105.130
<4>Partition check:
<4> sda: unknown partition table
<4> sdb: sdb1 sdb2 sdb3 sdb4 (NETBSD partition table, LE, offset 64)
<5>Looking up port of RPC 100003/2 on 136.201.105.129
<5>Looking up port of RPC 100005/1 on 136.201.105.129
<5>VFS: Mounted root (NFS filesystem).
<4>Freeing unused kernel memory: 48k freed